For the complete documentation index, see llms.txt. This page is also available as Markdown.

Baremetal and virtual machine

Applies to: SBC 3.1, 3.3

Transcoding Unit Configuration

Perequisites

*ProSBC Host Configuration

Network device name

Purpose

Network device role

Network Config

mgmt0

Management port

mgmt

Untagged

wan0

SBC port

LAN/WAN

Tagged 1650 (or other)

lan0

SBC port

LAN/WAN

Tagged 1651 (or other)

ctrl0

control port

ctrl0

Tagged 750

ctrl1

control port

ctrl1

Tagged 751

trans

transcoding port

LAN/WAN

Tagged 752 NOTES: * The 'Network device name' for transcoding must be trans. To have redundancy, the trans port bonding (using trans0 and trans1 physical ports) needs to be created at initialization time. * For baremetal, the trans port bonding, using trans0 and trans1 physical ports must be bonded at initialization time. You can look here for reference: Initial Configuration (Search for "Bonding") * For virtual machines, the virtual ports trans0 and trans1 are bonded in the Hypervisor layer of the virtual machine (optional) and the tran interface is presented to the guest (the ProSBC). *Hardware Unit - TB002177 is the TSBC-HW-TRANS unit in the below setup.

Network device name

Purpose

Network device role

Network Config

voip0

transcoding port

trans

Tagged 752 (Bonded with voip1)

voip1

transcoding port

trans

Tagged 752 (Bonded with voip0)

eth0

control port

ctrl0

Untagged PVID 750 **

eth1

control port

ctrl1

Untagged PVID 751 **

Configure IP Network for trans

*Create vp_trans virtual port: **Name: vp_trans **Ethernet Ports: trans **VLAN name: vlan_752 **VLAN id: 752 *Create trans IP Address: **Name: trans **Service to use: RTP **Host VLAN: vp_trans:vlan_752 **IP address: 192.168.152.1 **Netmask: 255.255.255.0

Add transcoding unit

*Show transcoding unit *Add TB002177 transcoding unit === Transcoding unit network configuration ===

Configure IP Network for voip ports

*Modify voip virtual port: **Name: vp_voip **Untagged: unselect **VLAN id: 752 **Physical Ports: Use voip0 and voip1 (ctrl-click) *Modify voip IP Address: **Interface Name: voip **Service to use: RTP **Virtual port: TB002177:vp_voip **IP address: 192.168.152.10 **Netmask: 255.255.255.0

Last updated

Was this helpful?