Configuring Tmedia M3UA ASP for a shared point code

Applies to version(s): v3.0 and above

This configuration is a standard M3UA Application Server Process (ASP)

Configure IP Interface	Configure SCTP	Configure MTP3 Point Codes	Configure M3UA	Configure ISUP	Configure NAP
*Configure IP Interface * In this use case, configured as: **IP Address: 192.168.0.99 **Netmask: 255.255.255.0 **Gateway: 192.168.0.1	*Configure SCTP	*Configure MTP3 Point Codes **In this use case, the following point code names are assigned: ***destination point code: dpc333 ***origination point code: opc111	*Configure M3UA ** M3UA Mode: ASP **Create an M3UA SAP **Create an M3UA Network **Create an M3UA User Part **Create an M3UA Peer Signaling Process ** Remote type: SGP ***Remote IP/Port for M3UA of SGP **Create an M3UA Peer Server ** In this use case, Two peer servers are needed: one local and one remote **Create an M3UA Route ** In this use case, two M3UA routes are needed: ***Local Route: Psrv, opc111, Local peer server, M3UA Userpart, subservice=NONE ***Route towards SGP: Psrv, Remote peer server, dpc333, M3UA Userpart=NONE, subservice=NONE	*Configure an ISUP Stack *Create an ISUP Network *Create an ISUP User Part *Create an ISUP Interface *Create ISUP CIC Groups	*Configure NAP