Ctrlk
ProSBC ProductLearning CenterHelptelcobridges.com
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Creating an MTP3 Route for STP

Applies to: Tmedia 3.0, 3.2, 3.3

MTP3 routes are designed to route traffic from previously created point codes using linksets.

You require one route for each point code in your system. This means one route per DPC (SSP and STP) and one route per source point code (OPC).

Note

Note

For STP, you need to allow TFA/TFP/TFR MTP3 management messages to pass. Please check the advanced settings below.

To create an MTP3 route:

1- Click MTP3 in the navigation panel.

Mtp3 0 A

2- Select an MTP3 network.

Create MTP3 Linkset 0

3- Click Create New Mtp3 Route in the MTP3 network configuration window:

Create MTP3 Route 0

4- Configure the new MTP3 route:

  • Enter a Name for the MTP3 route

  • Select a Point Code for the MTP3 route - OPC will be used for a local route, otherwise it will be DPC

  • Select a Point Code Type - select STP if the MTP3 route points to an STP (or for the local route, since it is an STP)

  • Click Create

Create MTP3 Route 1

  • Select Advanced Parameters

    • Check the Route to Adjacent box, if this route is directed to an adjacent network (directly connected with MTP3 linksets)

    • Check the Broadcast box (to transfer TFA/TFP/TFR MTP3 management messages) MTP3 STP route config 1 A

5- Verify that the "Mtp3Route was successfully created" message appears

Create MTP3 Route 2

6- Associate the newly created route with a linkset:

  • Select a linkset from the list of Available linksets

  • Click the "<<" button to associate the linkset with the newly created route

BEFORE Create MTP3 Route 3a

AFTER Create MTP3 Route 3b

Path

Parameters (text)

Parameters (json)

List of Parameters

PreviousCreating an MTP3 Route
NextCreating an SCCP GTT Address Map

Last updated

Was this helpful?