Ctrlk
ProSBC ProductLearning CenterHelptelcobridges.com
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Creating the M2UA Configuration

Applies to: Tmedia 3.0, 3.2, 3.3

To create your M2UA system, you must create a new M2UA configuration.

M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the MTP2 Layer of a signaling gateway to the MTP3 Layer of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.

To create an M2UA configuration:

1- Click M2UA in the navigation panel

Create M2ua 0

2- Create the M2UA configuration:

  • Enter a name for the M2UA service

  • Select a Node Type (SG, ASP, M2UA-MTP2 Relay)

  • Click Create

Create M2ua 1

3- Verify that the "M2ua Cfg was successfully created" message appears

Create M2ua 2

Path

Parameters (text)

Parameters (json)

List of Parameters

PreviousCreating the M2PA Configuration
NextCreating the SCTP Configuration

Last updated

Was this helpful?