For the complete documentation index, see llms.txt. This page is also available as Markdown.
Creating an H.248 Configuration
Applies to: Tmedia 3.0, 3.2, 3.3
After you create the necessary VoIP and TDM NAPs, you can create an H.248 configuration.
1- Click H248 in the navigation panel
Create H248 0
2- Create the new configuration:
Select a transport protocol type
Enter a public IP address
Enter a private IP address
Click Create
Create H248 1
3- For 1+1 systems, open the "Advanced Parameters" and then "Behavior" section and make sure this option is checked: No failover service changes
4- Verify that the "TbgwH248Cfg was successfully created" message appears
Create H248 2
NOTE: After creating the H.248 Configuration the Advanced Parameters will split into two sections to indicate which parameters will cause active calls to drop. These are labled as H.248 Service Affecting Parameters
