Toolpack system systemId reconfiguration 2-7

This procedure explains how to change the SystemId of a Toolpack system.

Step 1: Backup the current database

• Backup and download the database dump from the Web Portal

Step 2: Stop the Toolpack service

• Stop the service tbtoolpack stop OldSystemId

Step 3: Install Toolpack with new SystemId

• Use the Toolpack installer to install Toolpack on the new SystemId:

System reconfiguration procedure for Toolpack release v2.3

Step 4: Update database system ID

• Connect to the database. mysql -utbdb -p -h 'MyHostName' toolpack_0

• Modify the system_infos table UPDATE system_infos SET gw_port='NewSystemId' where gw_port='OldSystemId';

• Exit exit

Step 5: Change the SystemId of all the Tmedia and TMS

• Telnet to a Tmedia

  • For example, on a TMG, "telnet 172.31.1.1"

• Enter the 'set_boot' command

• Press enter until you see the following line: gateway port (TBX_GW_PORT=OldSystemId)? :

• Enter the new SystemId value

• Press the Enter key

• Press Ctrl + c

• Reboot the Tmedia reboot

• Repeat those steps for all the Tmedia and TMS of your system

Step 6: Start the Toolpack service

• Start the new service tbtoolpack start NewSystemId

Step 7: Uninstall the old Toolpack service

• Uninstall the old Toolpack service (NOTE: uninstalling the service will not erase the [InstallDir]/toolpack/setup/[OldSystemId] directory) tbtoolpack uninstall OldSystemId

Step 8: Enable the new Toolpack service at startup

• If you want the Toolpack service to start when the host boot, enter the following command: tbtoolpack enable NewSystemId