For the complete documentation index, see llms.txt. This page is also available as Markdown.

Configuring TMG7800 Ethernet Bonding

This article applies to:

Product

Version

Tmedia

3.0, 3.2, 3.3

Ethernet Bonding enables two Ethernet ports to be used as bonding pair. This ensures for a reliability of service. If the active port becomes unusable the other port in the bonding pair is used to transport traffic.

To configure Ethernet Bonding:

1. Select Hosts from the navigation panel.

  1. Select a Host from the Hosts Configuration list.

  2. Click the Status tab. *Select Change Network Devices Role.

  3. Select Reset Host Role.

  4. A Role Configuration window is displayed. *Set LAN/WAN role to the 2 Ethernet interfaces you want to bond.

  • Click add bonding

    • The bonding pair is displayed below.

  • Give a name to the bond.

  • For each LAN/WAN select the associated interface for the bond

  • Click continue

To verify the Ethernet Bond:

  1. Select IP Interfaces from the navigation panel.

2.The bond0 ports are shown.

  • Click the Status tab.

  1. Click the Ethernet Bondings Tab.

  • Select a Host to view more details.

  • An Ethernet bonding status window is displayed

Last updated

Was this helpful?